Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 1, 2008 17:00:12 GMT
Last Night on my way back from the motorshow. The Train i was on, at every station, The Train Doors Opened/Closed but the PED's had a 10 sec delay. Any Idea's Why  What was the incident at Nth Greenwich last night. Trains were non stopping. |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 1, 2008 19:45:26 GMT
Perhaps there was a fault on the drivers console, and had to get up and use the cab backwall panel to open up... or a fault with the the actual train to door interface system?
|
|
|
|
Post by happybunny on Aug 1, 2008 23:26:17 GMT
Or maybe if it was a new T/Op and they were still a bit shake'y in the PED areas they were stopping in the correct places, causing doors to have to be done manually. Even if you stop a couple of inches short, then pull up perfectly to the correct position, usually it will be too late and the doors will still have to be done manually.
|
|
|
|
Post by Tubeboy on Aug 2, 2008 0:23:24 GMT
Yep, could be a fault with the train equipment, or as HB said, a new driver.
As to NOG, there was an incident outside the station that required the attendance of the police....no idea what the incident was.
|
|
|
|
Post by glasgowdriver on Aug 4, 2008 23:38:36 GMT
when i used to work on the jubbilee line when this used to happen i spoke to a DMT when he was passing thro he said that slow ped closures happen when the train/op presses the buttons to quickly for the train to respond to the equipment that tells the PED'S to open/close
|
|
